Parkzone Ultra Micro J-3 Cub RTF

Parkzone Ultra Micro J-3 Cub RTF

Parkzone continue to expand their range of scale indoor electric flyers with this delightful ready to fly Piper J3 Cub.

The all foam ready to fly one-piece model features an under cambered wing section designed to allow the model to be flown slowly and an upper wing surface with moulded in wing ribs and doped fabric effect finish for a more scale like appearance.

The engine cowling is complete with dummy Lycoming engine cylinders whilst the lower fuselage has a convenient moulded battery placement "pocket". The model is finished in a scale Piper yellow colour scheme with black accents, registration numbers and of course the Piper Teddy Bear logo on the tail-fin.

On board the 2.4 GHz fully proportional three channel electronics controlling throttle, elevator and rudder are pre-installed with sprung carbon pushrods to the rudder and elevator. The steerable tail wheel and scale looking sprung wire landing gear comes complete with lightweight foam Cub "doughnut" wheels, enabling the model to take off and land on smooth surfaces.

This one box purchase comes complete with everything included, a 2.4Ghz transmitter, 1S 3.7volt 120 mAh Li-Po battery and Li-Po balancing charger powered by 4 AA dry batteries. With no further building or additional purchases needed this super little model can be in the air in no time at all.

Designed primarily for indoor flight and weighing in at a mere 25 grams this super model is sure to delight indoor pilots with its scale like flying characteristics and good looks and there is no doubt that this great little model could also be flown outdoors in very calm conditions when there is little or no wind.

http://www.horizonhobby.co.uk/aeroonline/e3parkzone/e3_pkz3900_j3_cub/e3_pkz3900_micro_cub_video.html